Advanced Tool Design Model ATD-3404 Condenser Fin Straightener

Comments

1. Sam says:

   January 26, 2010 at 6:17 am

   Unfortunately, it was not just the flippers on my A / C unit. I was not a section to adjust. Well built and well priced if you can, that it works. Rating: 4 / 5
2. R. Tong says:

   January 26, 2010 at 6:30 am

   Have not for my work, I have a Frigidaire FAA055P7A who obviously liked to CA to buy here at Amazon. I have not followed all the previous commentators head and fins as measured with a ruler before you buy me was about 12 cm so I thought it would work in my area. He did not. Rating: 3 / 5
3. G. Prentice says:

   January 26, 2010 at 7:54 am

   It only took a few minutes to perfect my technique in using this tool and after that my air conditioner fins look like new. I wish I could measure the efficiency, but by appearance alone, it is 100% better. Rating: 5 / 5
4. Marc Abramowitz says:

   January 26, 2010 at 8:44 am

   I actually bought the fins to straighten my Carrier air conditioning. Unfortuantely, says the packaging is for the radiator and tried to use all 6 sides of my air conditioning and match any of them. Rating: 4 / 5
5. E. McLemore says:

   January 26, 2010 at 8:56 am

   This tool has reached a new package and straighten very practical bent fins on my air conditioning system. Product information could not be found in the shops. Rating: 4 / 5